wamp
Active Member
Posted by Maury:
I am just installing and programming my aquacontroller 2. The problem I am having is getting the X-10 appliance modules to work. I have a 250W single bulb PFO ballast plugged into one of the control units. When I enter manual control mode and tell the switch to switch off, nothing happens. The Light is set to LT1, code number A01, and so is the control module. It's not a programming problem. I have tried moving the control module and interface module (the one connected to the controller with the phone cord) to different plugs. Even put them both on the same power strip. What could be the problem? Am I getting interference somewhere? If so, how can I test for this?
I am just installing and programming my aquacontroller 2. The problem I am having is getting the X-10 appliance modules to work. I have a 250W single bulb PFO ballast plugged into one of the control units. When I enter manual control mode and tell the switch to switch off, nothing happens. The Light is set to LT1, code number A01, and so is the control module. It's not a programming problem. I have tried moving the control module and interface module (the one connected to the controller with the phone cord) to different plugs. Even put them both on the same power strip. What could be the problem? Am I getting interference somewhere? If so, how can I test for this?