Can someone tell me what I am doing wrong?

wildman1

New Member
I am trying to glue frags to existing rock under water. I am using superglue gel but it is not holding.
Thanks in advance.
 

mr_x

Active Member
take the frag and rock out of the water. glue the frag on. submerge the end result gently, because it will take a few seconds for it to dry.
 

errattiq

Member
apply generous amount of gel to frag out of water (pat dry frag base first). quickly place where you want the frag underwater and hold it for 30 seconds... always works for me
 

wildman1

New Member
I cannot remove the existing rock without breaking everything down. I should have mentioned that first.
I will try and use more. Maybe that will help.
 

reefkprz

Active Member
dry the end opf the frag you are trying to glue and apply a small bubble of glue to it. figure out where you want the coral glued and squeeze some glue onto that area, then press the two portions of glue together breaking the "skin" that will have formed on oth sections of glue. this works rather well it just may take a couple trys to get used to.
 
Top