i got a problem

donzo

donzo

Member
I been having a problem with my tank, not the water or anything, but its leakin
and me and my dad have been putting silicone on the side but it keeps leakin...What should i do? i got a hex and its pretty high, and the hole is about half way down...would it be a good isea to take out the water and fix it from the inside...i guess i would have to keep the water in somethin...if anyone knows anything please leave something...thank you
 
scubadoo

scubadoo

Active Member
1. Locate the exact source of the leak and mark it with a felt tip marker.
2. Reduce the water level in the tank until the leak stops.
3. Thoroughly dry and clean the area of and around the leak with a paper towel, or soft cloth.
4. With the razor blade, scrape the existing silicone from the leaking area, and an additional one inch area around the source of the leak.
5. Clean the scraped area with the acetone applied to a paper towel, being careful not to over staturate it or allow any acetone to run or drip down into the aquarium, and let dry for a few minutes.
6. Apply the silicone sealant to the cleaned area, working it into the glass joint area.
7. Allow the silicone to cure for at least 12 hours, 24 is better.
8. Refill the tank with water to the desired level.
9. Check to see if the repair worked and the leak has stopped.
 
You must log in or register to reply here.
Top