Icecap POWER CORD confusion

[thommyboy121]

So the two pictures are of the wires and ballast (icecap 660) that I have. I am planning on wiring it soon....but there's a problem: I can't figure out how to connect the power cord to the ballast. There is a connection, but it's one of those clip on connectors, and it has 4 wire connection parts. Please help...and if you do, don't tell me to google it (Im just a little bitter because I pretty much get that every time. I wouldn't be asking the question if I looked it up on google)
every one says that the icecap is so easy to setup, and the wiring is so easy. I don't understand why they didn't just use a real picture instead of a drawing. Am I stupid or am I just missing a piece?
Attachment 244691Attachment 244692

 

[posiden]

The reason you don't have a connector for the 4 pin, is that's not the power in for the ballast. Wiring diagrams can be a bit confusing to some folks some times. HTH.
Here is a pic of my spare 660. You can see the wires I have spread apart in this pic.

This pic shows all the wires paired together and shows you the power wires on the right side. The black, white, and green wires. The others are the pairs that go to the end caps for the bulbs.

 

[thommyboy121]

Thank you so much, I do feel a little stupid for not thinking about why there were 3 shorter wires (all green, black, and white)...but oh well
thanks again

 

[posiden]

Originally Posted by thommyboy121
http:///forum/post/3290677
Thank you so much, I do feel a little stupid for not thinking about why there were 3 shorter wires (all green, black, and white)...but oh well
thanks again
Not to worry. We all get blinded some times.
I'll pull a pint just for you, OK.