blane perun
Member
Ion Exchange recharge vessels DIY.
I’m not if there are people out there like me using sure the Kati and Ani Ion Exchange Units. If there are maybe you have struggled to find a good holding vessel like I had for the recharge solutions.
The recharge can get a bit messy working with Muriatic Acid and Caustic Soda, not to mention ruin clothes. In the past I have used numerous vessels to hold the solutions for recharge but, none had lasted long nor was I happy with the simplicity.
In a recent trip to Wal Mart, found a cheap plastic gasoline can with a capacity of 2 gallons. The cost was about $3 bucks. In addition I bought a spill proof extender which
Came with some nice plastic tubing and the Inside diameter fits snugly around the tubing used for the DI. The extension was another $3 bucks.
After my first attempt I quickly learned the spill proof extension was not so spill proof.
It leaked a bit with a pesky drip, might not matter if I were outside but I certainly did not want the acid dripping on the floor. I remedied this by sealing the threads with a two part quick set automotive epoxy.
I was able to pick up at a local hardware store. The setting time was about 30 seconds.
Here is the extension after it was sealed, I worked the epoxy into the joint by using a
Plastic toothpick.
To control the flow rate, I use what I think everyone does some a small plastic needle valve and airline tubing. It’s worked well to date and I am able to dial down the output fairly accurately.
Here is the unit in operation. I elevate the gasoline can with a milk crate and garbage can turned upside down. Near the end some solution remains in the gas can, and I tilt the right side up with some PVC to drain the rest out. So far its been working well with no leaks.
and the fill up
blane perun
I’m not if there are people out there like me using sure the Kati and Ani Ion Exchange Units. If there are maybe you have struggled to find a good holding vessel like I had for the recharge solutions.
The recharge can get a bit messy working with Muriatic Acid and Caustic Soda, not to mention ruin clothes. In the past I have used numerous vessels to hold the solutions for recharge but, none had lasted long nor was I happy with the simplicity.
In a recent trip to Wal Mart, found a cheap plastic gasoline can with a capacity of 2 gallons. The cost was about $3 bucks. In addition I bought a spill proof extender which
Came with some nice plastic tubing and the Inside diameter fits snugly around the tubing used for the DI. The extension was another $3 bucks.
After my first attempt I quickly learned the spill proof extension was not so spill proof.
It leaked a bit with a pesky drip, might not matter if I were outside but I certainly did not want the acid dripping on the floor. I remedied this by sealing the threads with a two part quick set automotive epoxy.
I was able to pick up at a local hardware store. The setting time was about 30 seconds.
Here is the extension after it was sealed, I worked the epoxy into the joint by using a
Plastic toothpick.
To control the flow rate, I use what I think everyone does some a small plastic needle valve and airline tubing. It’s worked well to date and I am able to dial down the output fairly accurately.
Here is the unit in operation. I elevate the gasoline can with a milk crate and garbage can turned upside down. Near the end some solution remains in the gas can, and I tilt the right side up with some PVC to drain the rest out. So far its been working well with no leaks.
and the fill up
blane perun