briandg
Member
I just installed my new RODI unit in my garage today. I tapped into the cold water line before it goes into the hot water heater. I got it set up fine, put in the membrane, checked and no leaks. So far so good. I ran it for about 2 hours and threw out the water. Now I'm filling a bucket of the water. I just tested it, and it's registering 53 on the tds meter after DI. It's a 6 stage unit bought of the famous
[hr]
site. It's a DEVONEB 100 gpd. It's producing water at a slow drip. Any advice would be greatly appreciated. My water tests at about 113 on the TDS meter straight from the tap.
Thanks
[hr]
site. It's a DEVONEB 100 gpd. It's producing water at a slow drip. Any advice would be greatly appreciated. My water tests at about 113 on the TDS meter straight from the tap.
Thanks
. I didn't have the flow restrictor turned on, so basically, I was just flushing the system for the past 2 hours
