Tunze Problem
- Thread starter stdreb27
- Start date
reefraff
Active Member
You may have removed a bump stop when you modded the shroud. It's been a long time since I've used a stream so I can't remember if they have one for sure. I know Maxi Modes use one so if the pump starts in reverse the prop shifts forward and hits the stop which causes it to bounce off and reverse direction.
stdreb27
Active Member
Originally Posted by reefraff
http:///forum/post/2893373
You may have removed a bump stop when you modded the shroud. It's been a long time since I've used a stream so I can't remember if they have one for sure. I know Maxi Modes use one so if the pump starts in reverse the prop shifts forward and hits the stop which causes it to bounce off and reverse direction.
Well, that happens, I did move the bumpstop. And it doesn't always start going forward.
The problem is, they will randomly change directions. I'm wondering if that is a power flow issue or what?
http:///forum/post/2893373
You may have removed a bump stop when you modded the shroud. It's been a long time since I've used a stream so I can't remember if they have one for sure. I know Maxi Modes use one so if the pump starts in reverse the prop shifts forward and hits the stop which causes it to bounce off and reverse direction.
Well, that happens, I did move the bumpstop. And it doesn't always start going forward.
The problem is, they will randomly change directions. I'm wondering if that is a power flow issue or what?