AI Hydra 26 help please

snakeblitz33

snakeblitz33

Well-Known Member
My daughter turned off my powerstrip on my aquarium and it was off half a day while I was gone.

When I turned the power strip back on, everything came back on but my AI Hydra 26 led light. I tried unplugging it and plugging it back in. I tried manually turning it on. I tried holding the manual button down. I held the button down and pulled the power cord out, thinking that it would restore to factory default. None of that worked.

I have neither a controller nor a director.

I tried the light in multiple different outlets as well. I'm worried that it burnt out or is ruined. Any help is appreciated.
 
2quills

2quills

Well-Known Member
Probably just going to have to contact them, Seth.

Does the status led even come on?
 
2quills

2quills

Well-Known Member
On my first gen hydras it's on the back where the power supply plugs in. The reset button is on one side of the cord, the led indicator is on the other side.

Normally it should be green.

If it's not lit up at all then it's probably a power supply issue. Just double check your cords are pushed in all the way on the power supply is about the only help I have for ya.

Did you hold the reset button down for a full 8 seconds?
 
You must log in or register to reply here.
Top