AquaC Remora (Need to know ASAP)

reefeel

reefeel

Member
I am thinking of asking for an AquaC Remora for Christmas. My tank is a liile more then 2.75 in from the wall. Can someone give me the exact width sites say different things and I want to make sure? Also are these pretty good, right now I have a cheap Red Sea Airstone driven counter current and it sucks.
 
legion

legion

Member
I measure it at almost exactly 2.75(just under), this is the non-pro. If you set it that close you will proly have to unscrew the feet on the bottom that rest on the back wall of the tank.
I find it pulls out a wet skimmate, but it definitely takes more out than my old prism did and requires almost no adjustment
 
reefeel

reefeel

Member
The problem is, is that I don't have a sump. My wet-dry filtration is built into my tank back and I only have minimal room for a in tank skimmer.
 
nas19320

nas19320

Active Member
You can't pull that tank out from the wall some? Remora's are some of the slimest skimmers there are.
 
T

tizzo

Guest
You're gonna have to do some serious sanding (it's 3.25")!! You may want to check the Bak-Pak also...
 
legion

legion

Member
the non pro is 2.72 on my tape measurer, if you want I could get my caliper or micrometer from work and check for an exact measurement?
 
T

tizzo

Guest
I guess Legion just said it. Mine is a Pro.:D
I didn't even know there was a diff til now.:nope:
 
steveoutla

steveoutla

Member
Or you could just drain some of the water and move your tank out about 3". sounds like a nice Saturday project. Then again, you could always cut the wall.
 
You must log in or register to reply here.
Top