sharkbait9
Active Member
Ok I need some glass cutters to help me out. I have been practicing with some glass Diamond Core hole Drill Bit and pretty much have master the hole drilling technique. I have to know what size hole bits I need to order to make holes for a 1 inch bulkhead and 3/4 inch bulkhead and a half inch bulkhead.
I think, if I measured right I will need a 1.5 inch hole for a ¾ bulkhead.
Any one else? Size needed.
I like the using the diamond core hole bits better then using a drill bit. A lot easier and makes a nice hole.
I am able to go thru single pane glass (picture frame glass) all the way thru a ½ piece of glass.
The bits take to long and fade so quick no matter how wet and cool I kept them.
The core bits are a little more money but so much more worth the peace of mind and so less time consuming.
Thanks
I think, if I measured right I will need a 1.5 inch hole for a ¾ bulkhead.
Any one else? Size needed.
I like the using the diamond core hole bits better then using a drill bit. A lot easier and makes a nice hole.
I am able to go thru single pane glass (picture frame glass) all the way thru a ½ piece of glass.
The bits take to long and fade so quick no matter how wet and cool I kept them.
The core bits are a little more money but so much more worth the peace of mind and so less time consuming.
Thanks