E
eric b 125
Guest
i posted a few questions in the DIY section, but i've come up with a few more ?'s and figured i'd give this forum a shot for the answers.
I'm drilling my 125, and i was going to do a center 1500 gph overflow from glass-holes in the center, with corner returns, but it would make my plumbing easier (both drain and returns) if i put dual 700 gph overflows in the corners with the return in the center. i also figure the flow, with some korillas, would be better with more currents.
i'm drilling my return, by the way. i've seen things that pre-drilled tanks use to direct flow in the tank. they are black, flexible tubes, that have pieces that connect to the end. is this what loc-lines are? if so, is there one that goes from one drilled hole, and y's off to direct the flow into two directions, or should i drill two holes and y both of them off so there's 4 different directions? thanks for your help.
I'm drilling my 125, and i was going to do a center 1500 gph overflow from glass-holes in the center, with corner returns, but it would make my plumbing easier (both drain and returns) if i put dual 700 gph overflows in the corners with the return in the center. i also figure the flow, with some korillas, would be better with more currents.
i'm drilling my return, by the way. i've seen things that pre-drilled tanks use to direct flow in the tank. they are black, flexible tubes, that have pieces that connect to the end. is this what loc-lines are? if so, is there one that goes from one drilled hole, and y's off to direct the flow into two directions, or should i drill two holes and y both of them off so there's 4 different directions? thanks for your help.
