Total Amps???

superluker

New Member
Has anyone figured out how many amps their set-up uses? I'm trying to figure out the best way to plug everything in without tripping a breaker. Any suggestions???
I haven't bought the set-up yet... but I want to make sure that my house's wiring can support the load. I want to run a 110gal (48x18x30) reef tank. I would like to be able to support a anemone after my tank is established. What kind of lighting would I need and how many watts and volts do they put out?
 

superluker

New Member
Any help would be much appreciated. I want to avoid tripping a breaker while I’m at work and all of my live stock dies. Witch bring up another question, what does everyone do if there is a power outage??? :help:
 

stone

Member
I think there is alot more stuff you should be putting your energy researching instead of amps. My house was built in 1919 and I have enough stuff on my system to power a village. If you can spread it over more than a single circuit and try not to use a circuit that has a big load like a ac unit, dishwasher, washing machine. The only time I have had a problem is when my GFCI trips due water dripping for some reason. But if you want to add up all the amps I guess better safe than sorry
 

superluker

New Member
How could I spread the load out??? There is only one outlet where I can put my tank. Can I install a new circuit and new outlet?
 

stone

Member
Well, I think you should buy your set up and not worry about amps. Then you will have plenty of time to test it with all equpment before you get any live stock. If there is any problem its no big deal to add a circuit even if you had to pay someone.
 

pchromis

Member
I agree with Stone,,
Don't worry too much about amps. As you purchase equipment, each unit has the electrical specs on it. For instance a powerhead that is using, say, 7.5 watts is only drawing about .065 amps. A typical 15 amp circuit is ample for an average aquarium setup.
 
Top