bkvreef
Member
Tim I thought I'd start another since my last post was getting of the initial idea.
Heres my plan:
55g (48 x 13 x 21) sump under my 100g dt
right intake into sump (will hold p.s., and phos-ban reactor will flow into this area). This section will be as small as possible (hopefully 17"). Will also have filter floss, in a sock from tubes, to elimiante large particles.
middle refugium with sand bed and macro algae, maybe mangrove. Would like this section to be about 18"
left pump area around 10" to give extra space so evaporation isn't as noticeable.
In my calculations for backwash (during poweroutages) I would need 4.25 inches. I had planned on making the baffles about 16 inches high. with 1.5" seperating them.
I will make these out of glass. Is there a particular type or thickness I ask for when I go to get it cut?
What type of glue would you use for the glass?
Also where would you put live rock rubble?
Any other additions to the refugium?
Heres my plan:
55g (48 x 13 x 21) sump under my 100g dt
right intake into sump (will hold p.s., and phos-ban reactor will flow into this area). This section will be as small as possible (hopefully 17"). Will also have filter floss, in a sock from tubes, to elimiante large particles.
middle refugium with sand bed and macro algae, maybe mangrove. Would like this section to be about 18"
left pump area around 10" to give extra space so evaporation isn't as noticeable.
In my calculations for backwash (during poweroutages) I would need 4.25 inches. I had planned on making the baffles about 16 inches high. with 1.5" seperating them.
I will make these out of glass. Is there a particular type or thickness I ask for when I go to get it cut?
What type of glue would you use for the glass?
Also where would you put live rock rubble?
Any other additions to the refugium?