Search results

does any one know how to install this?

on both end of the restictor look like connection for the tube (water line) to go in and out i was think of cut the feed water line and connect that in the middle what do you guys think?

thanks any way but i finally found it

same here can you guys send me a pm or an email about the ecomod been looking around for it and some member in the forum don't want to help thet992004@yahoo.com

Originally Posted by sign guy its a very small pice of plastic and it should be where your rejected water line meets your pressure vessel. you just un s_crew the fitting and pul the line away from the unit and it'll fall out. yes its a one time thing and they are fairly cheap no more than 10...

very simple just take a tube and stick it into the u tube and suck the air out that will start the suction

what kind of sands are you using?

Originally Posted by sign guy you also have to change your flow restrictor where is the flow restrictor in the unit? is it just the one time replacement?

can i use an external pump for the chiller? if so then i would need to connect the pump before the chiller right or can i connect it after the chiller?

i have a 50 gpd coralife ro unit with 3 canister which of these do i need for the 3 canister 1 Micron Purtrex Depth Sediment filters 5 Micron Purtrex Depth Sediment filters 0.6 Micron MATRIKX® +1 Carbon Filter Cartridges 5 Micron MATRIKX + CTO/2 Carbon Filter and what is this? Flow Restrictor...

thank you

can i replace a 75 gpd membrance for my 50gpd ro unit? will it make it into a 75gpd then?

yes sir

finally i got the close loop running but the ocean motion is not working proberly. hopefully after this i could start mix some salt water.

if i have (2) 1" pvc run into both of the chamber and come back down into the pump will it be enough water for the overflow? or should i run that outside of the overflow? it would be a lot cleaner if i could hide as much pipe as i could or maybe i could try and have it inside of the chamber...

i have a 220

Originally Posted by cannarella Your inlet hole is starving the pump. Not good. You need a huge inlet hole for this pump if not multiple small inlet holes. It has a 2" inlet and it will use all of it. This pump is made for volume pumping and you don't want to restrict the suction side at all...

ok I used the return from my overflow for the intake. It works fine but seem a little weak and it suck in too much water which I was thinking drilling more hole so more water can come in the chamber. the hole only 1" is that ok?

is the 1" inlet hole ok for the dart pump 3600gph? it seem a little weak, doesn't shoot out much water

nice