Originally posted by golfish
It might sound like I'm harsh, if so then I apologies. Its just in the way that I write.
You can be hard to "read" sometimes too...
<<notice smile... Perhaps I am too...:thinking:
"ALL" my posts are best taken with a grain of salt(water) and I too apologise if you misread my intentions (although I "do" use a lot of smilies
)
But back to the original question...
I have seen this type of impeller (modified needle wheel or "brush) on Ocean Runner and Aqua Medic pumps of various sizes...
And if you have a "box" full of them like I get from time to time you may be able to "cross fit" and shim one into another...
As long as the magnet diameter is close and you can find/make a shaft to fit... :yes:
Another "option" to get the same effect is to take the "wide" blade impellers and cut slots in them and then "bend" the tabs slightly to get a "brush like" effect... I did that on a Maxi I was "adapting" during the Sea Clown Modification series....Going for "induction" rather than Venturi effect to increase preformance...(did get "slight" improvement)
Doesn't take much for you to act like an ***H*l*
Actually, I'm more of an "Instant ***H*l*... Just Add Alcohol"
:hilarious
