you can seed your fuge with pods by buying them, or you can sift some out of your DT and throw them in there.
Check out this
*please do not post links to other sites that promotes other boards or stores.*
OK, Ive posted this link before and it wasnt deleted? So I guess Ill make a monster
post of what was in the link.
PART ONE OF COPEPODS
Copepod Culturing:
There are many reasons to culture copepods and each of these reasons has its own set of requirements to gauge success. For purposes of this discussion, we will use the basis of culturing copepods to provide more diverse live food for a reef aquarium. It should also be understood that this is only one way to achieve the desired results and like most things in this hobby, there are many ways to achieve success.
Parts:
The first step, as in any project, is to assemble the parts we will need for the project.
1 – 10 gal tank
1 – Small air pump
1 – 2 gang air valve
1 – 36" ¼" rigid tube (cut in two equal pieces)
1 – 12" section of ¼" airline
1 – 24" section of ¼" airline
1 – 36" section of ¼" airline
1 – Acrylic lid with holes for rigid tube
Assembly:
The next step is to assemble the parts.
1) Connect the air pump to the gang valve with the 12" section of ¼" airline.
2) Connect each gang valve to the two remaining sections of airline.
3) Connect a piece of rigid tubing to the ends of the two airline sections.
4) Insert the rigid tubing in two of the holes in the acrylic lid. Place them at opposite ends of the tank. This will allow for better flow through the tank.
Select a source for phytoplankton to feed the Copepods
Phytoplankton can be found from many sources, including home culturing. Commercially available phytoplankton will tend to be more concentrated than home grown cultures. Pictured here are examples of DT's Live Marine Phytoplankton, Reed Mariculture's Plankton Live FeedDiet, and the typical 2-liter bottle of home grown phytoplankton. Which ever source you decide to use, make sure you use according to instructions to prevent contamination and spoilage.
Nannochlroposis is my preferred phytoplankton to feed copepods. Others may work as well or better, but Nannochlropsis is widely available from both commercial and home grown sources.
Once we have the phytoplankton, we need to fill the culture tank with an appropriate amount of phytoplankton. To prevent spillage and some of the mess, I typically fill the tank less than half full.
Now we have the culture tank filled and ready for copepods, not just yet. We need to make sure the culture tank parameters are within ranges.
Temperature – For culturing copepods, I do not use a tank heater. I have had great success with room temperature. So what is room temperature? It means a room that is typically considered comfortable. This does not include the room with no insulation on the Northwest side of a house on the plains of North Dakota in January.
Salinity – It is best to match the culture tank to the tank to be fed. This helps eliminate the possibility of salinity shock for the copepods.
Airflow – With the culture tank filled with phytoplankton, we can set up the airflow. This does not need to be forceful, but does have to provide some circulation. I found that adjusting the airflow to a rate slow enough to count the bubbles to be adequate.
Lighting – Ambient room lighting or low wattage fluorescent lighting.
Adding the Copepods:
If we've successfully completed all the above, we can now add the copepods. When adding the copepods try to insure they are near the same water parameters as that of the culture tank. If not, try to "acclimate" them slowly, although they are quite hardy. Standard acclimation procedures will work fine.