justinx
Active Member
I have seen a couple threads about this and some people have asked for it, so instead of posting this all over, i just started a new thread. This is how I have my hood wired (you guys actually made me take off my canopy for this ). Each blue dot is a waterproof (not resistant, there are both kinds) wire nut (It has a gel inside that solidifies when exposed to air) that connects three wires. Its kinda cramped in there so i used the extra large caps. I have not had any problems with this set up yet, and it is mounted entirely inside the canopy, ballast and all. I modified the fulham diagram slightly as this achieves the same circuitry with less hardware. I hope this helps you guys out. Let me know if you have any questions.