Search results

Actually, depending on how the stand is built and placed, and how big the foot print is, how new the building is and where the apt is located in the complex, it is possible to keep it. Mine is only a 160, but by by doing some basic math and resurch on the floor construction I have have...

very funny. Is the switch shaped like a flag?

Thanks. I found what I needed.

Well once again I need a little direction. I know everyone has an opinion about something, but what are the most reliable heaters and does anybody make a fully submersable with a remote thermostat?:cool:

use a ball valve and a smaller pump. if it's still too much, run thinner drain lines. Scratch that. I learn something daily here.

Good to know. Thanks for following up on your own post. Where did you get that info? I'm just curious.

Ageing is actually time for airating. You should airate the water with a air stone or something for a day or so, not just let it sit. This is because water has a low O2 level comming from the pipes and ground (yes even with an ro unit). It also allows for a strongrer ionic bond between the...

Hey puffercat, can you post or email me a pic of each? tkandsm@attbi.com

I've got $50 for it if you have a pic.

Cool. Check your mail.

Iwaki MD70RLT. I have a cs102 and a cs100 overflow. I'm most likly going to use a ball valve on each to control them. Any opinions? (like I don't already know eveybody here has one about something)

I'll take 1 for $20

There's a guy on ---- who sell's these new for like 10 to 15 dollars each. Sometimes you can even get a pair for 20. Just fyi.

I need a long tank for a sump. I can not go more than exactly 12" deep. Will pay shipping of course as long as the total is reasonable.

Is that a $100 for the sr9 or the berlin turbo? Or either? With pumps right..... Tim

I would prefer a Berlin turbo. Anybody have one?

get a hold of Beth. I think she has one.

actually it's a bit. And no, nothing special. Just a straight cutting bit 1/4" works well.

A fence is a straight edge mounted to something so you can either run the ruother against it and get a clean cut, or run the acrylic against it on a table saw to get a clean cut. A fixed straight edge that is used to guide something.

router and a fence. table saw and a fence.