acrylic51
Active Member
It's not perception with this product.....They are "junk"....No if ands or buts about it.......And as NikeSB pointed out sometimes on this forum we are blinded by just what is here.....We do need to stop and take a look at the vastness out there, and see that this isn't an isolated case.....These are know problematic heaters.....And yes you are correct there will be some varied or mixed reviews on equipment, suppliers or what not. The bottom line they have poor quality control, and regardless if they replace a 100 of them no charge!!!!!!
Why would a rational person even think about putting another of that type heater in their tank? I for sure wouldn't.....
I had an issue with Won Brother heater long ago.....They were the rave all over the place....Then they started to have issues....but like most....OOOhhhhh it's an isolated case....Wrong!!!! they were faulty, and all but burned through the bottom of my sump before I realized what was going on......Again anything can malfunction, but when it's a well known fact that it's poor, why even trust/risk using it?? Just like everything else in your tank is an investment....Why not spend a little extra cash on a proven, piece of equipment; instead of settling for run of the mill.....I'm using the Stealth as an example.....What's the cost??? Compare that to something like the EboJager heater!!!!! EboJager might be a few dollars more, but their reliability, and reputation, can't even be touched by Stealth......Ohhhh and might we dare spend a few extra dollars on a Finnex....with a separate temp controller.....Again it's all an investment guys!!!!!! Every piece of equipment we buy should be based off of quality, not necessarily convenience because the LFS sells them or this site....Doesn't mean a whole lot in my book just because they might be pushed he or there.....Word of mouth and track record are what counts......
Another way to reduce/or minimize the change of a heater sticking on would be to run it through a controller......the controller which monitors and controls the temp and what not, would realize the temp of the tank is out of whack and shut the power off to the heater, regardless of what the heater thermostat is stating....Again redundancy and safety backups are key in any system setup.
I had an issue with Won Brother heater long ago.....They were the rave all over the place....Then they started to have issues....but like most....OOOhhhhh it's an isolated case....Wrong!!!! they were faulty, and all but burned through the bottom of my sump before I realized what was going on......Again anything can malfunction, but when it's a well known fact that it's poor, why even trust/risk using it?? Just like everything else in your tank is an investment....Why not spend a little extra cash on a proven, piece of equipment; instead of settling for run of the mill.....I'm using the Stealth as an example.....What's the cost??? Compare that to something like the EboJager heater!!!!! EboJager might be a few dollars more, but their reliability, and reputation, can't even be touched by Stealth......Ohhhh and might we dare spend a few extra dollars on a Finnex....with a separate temp controller.....Again it's all an investment guys!!!!!! Every piece of equipment we buy should be based off of quality, not necessarily convenience because the LFS sells them or this site....Doesn't mean a whole lot in my book just because they might be pushed he or there.....Word of mouth and track record are what counts......
Another way to reduce/or minimize the change of a heater sticking on would be to run it through a controller......the controller which monitors and controls the temp and what not, would realize the temp of the tank is out of whack and shut the power off to the heater, regardless of what the heater thermostat is stating....Again redundancy and safety backups are key in any system setup.