sparty059
Active Member
Originally Posted by Posiden
http:///forum/post/3294588
If this were my tank I would make the return go out the back of the stand and run it up over the top to the return lock line. This way I could turn the two existing bulkheads into a Herbie drain method. Run the 3/4" bulkhead in a full siphon and let the 1" be the balance. Then you can split the 3/4" full siphon drain to both tanks underneath and have a totally silent drain setup. Run the 1" straight or as close to straight as you can into the sump tank only. This way its guaranteed to be silent in the drain department and you don't have to drill the display tank.
I don't think I can do this because of the canopy that I have. It has a small opening that will not allow me to put a pipe through... also, I have a cover over the overflow that won't let me cover it if I put a pipe in over the top. But this shouldn't be a bad thing if I can't do this... right? So you think I should just stick with the 3/4" bulkhead?... I was kind of thinking if I use the 1 1/2" then it'll be cutting the glass very close to the top you know? You think I shouldn't have any issue with overflow or any problems if I keep the 3/4" bulk?
http:///forum/post/3294588
If this were my tank I would make the return go out the back of the stand and run it up over the top to the return lock line. This way I could turn the two existing bulkheads into a Herbie drain method. Run the 3/4" bulkhead in a full siphon and let the 1" be the balance. Then you can split the 3/4" full siphon drain to both tanks underneath and have a totally silent drain setup. Run the 1" straight or as close to straight as you can into the sump tank only. This way its guaranteed to be silent in the drain department and you don't have to drill the display tank.
I don't think I can do this because of the canopy that I have. It has a small opening that will not allow me to put a pipe through... also, I have a cover over the overflow that won't let me cover it if I put a pipe in over the top. But this shouldn't be a bad thing if I can't do this... right? So you think I should just stick with the 3/4" bulkhead?... I was kind of thinking if I use the 1 1/2" then it'll be cutting the glass very close to the top you know? You think I shouldn't have any issue with overflow or any problems if I keep the 3/4" bulk?