The One Question-Answer Thread

florida joe

Well-Known Member
Phytoplankton are microscopic plants that grow in the upper regions of the ocean where sunlight is plentiful. These small plants, which are composed of algae, are the bottom of the food chain for the entire planet. Phytoplankton require light for photosynthesis, so they usually are found near the surface of the water. A wide variety of adaptations help them stay afloat. Some beat their flagellas and tread water. Others have fins and spines that act as water wings. Others store extra food as oil, which buoys them up near the surface.
When phytoplankton become full of oil, they die and sink to the bottom. They become buried under mud and sand. Over millions of years, heat and pressure within the earth transform the oil from the algae into crude-oil deposits that can later be used by humans.
Climate change has a profound effect on ocean circulation and mixing patterns, and these in turn control nutrient availability to the ocean's phytoplankton and their access to the solar radiation that is required for photosynthesis. During normal years, the Earth's oceans go through a process known as upwelling in which the easterly winds blow across the equator and drag the warm surface water with them. Then the denser, colder water from the depths of the ocean rises, restoring oxygen and allowing mineral nutrients to return to the surface where phytoplankton can use them once again.
 

florida joe

Well-Known Member
Originally Posted by Bang Guy
http:///forum/post/3185058
The Chloroplasts the algae uses for photosynthesis are green. I think Chloroplast literally means "green Stuff" or something like that in Greek.
Greek words chloros which means green and plast which means form or entity.
 

reefkprz

Active Member
Originally Posted by Bang Guy
http:///forum/post/3184153
Any idea how fast it's consumed?
was digging around I couldnt tell you how fast its consumed but I can tell you how much on average...
Strontium is consumed by corals at a rate of approximately 1.0% by dry weight (in SPS adn LPS) to build their skeletons. so for every ounce of skeleton grown your consuming 1/100th of an ounce of strontium. on average.
my suggestion would be a test kit and maintain NSW levels, overdoseing strontium is apparantly very dangerous, as it can cause all kinds of night mares like calcium precipitation toxicity in other marine organisms. Anything I find indicates there would be NO benifit to going over NSW levels in fact its reputed to be very risky.
also, strontium is used by young vertabrete animals to develop bones and teeth, retention of strontium can be around 90% in young animals while nearly 0% of strontium is retained in adults.
 

pezenfuego

Active Member
Phytoplankton: It should be noted that when using the word "plants" we are not saying that these organisms belong to the plant kingdom. They are in fact protists.
 

bang guy

Moderator
Originally Posted by reefkprZ
http:///forum/post/3185213
also, strontium is used by young vertabrete animals to develop bones and teeth, retention of strontium can be around 90% in young animals while nearly 0% of strontium is retained in adults.

This I find to be quite facinating. I wonder if a lack of Strontium was a reason why I was never able to raise the Dragonet larvae beyond 5 days... Hmmmmmm
 

keith gray

Member
Is there a thread or list of what abbreviations are commonly used on this cite. SOmetimes I read a thread that I don't understand the whole meaning because of an acronym I don't recognize
 

florida joe

Well-Known Member
Originally Posted by Keith Gray http:///forum/post/3185654
Is there a thread or list of what abbreviations are commonly used on this cite. SOmetimes I read a thread that I don't understand the whole meaning because of an acronym I don't recognize
seek and you shall find
ok i will give it to you https://forums.saltwaterfish.com/t/42388/bulletin-board-acronyms
 

drtito

Member
i have a 125 and i have played with powerhead placement for sometime now.
My question is, whats the norm on flow ......Left to Right ** OR ** Front to Back ??
 

xcali1985

Active Member
Originally Posted by DrTITO
http:///forum/post/3185947
i have a 125 and i have played with powerhead placement for sometime now.
My question is, whats the norm on flow ......Left to Right ** OR ** Front to Back ??
No one answer for this. I would say if you drop some mysis shrimp into the tank and it settles in an area, increase the flow there. Some parts of my tank are turbulent others are a peaceful flow and I don't use powerheads at all.
 

drtito

Member
Originally Posted by Xcali1985
http:///forum/post/3186013
No one answer for this. I would say if you drop some mysis shrimp into the tank and it settles in an area, increase the flow there. Some parts of my tank are turbulent others are a peaceful flow and I don't use powerheads at all.
the way i have mine set is a cyclon/hurracain all power heads help the water spin in a clockwise pattern/manner. I was thinking of going front to back my corals are blowing one way.
 

bang guy

Moderator
Originally Posted by DrTITO
http:///forum/post/3186083
the way i have mine set is a cyclon/hurracain all power heads help the water spin in a clockwise pattern/manner. I was thinking of going front to back my corals are blowing one way.
Mine is similar but it flows across the top, down the opposite side, along the bottom, and then up the near side and out the overflow.
 

drtito

Member
Originally Posted by Bang Guy
http:///forum/post/3186154
Mine is similar but it flows across the top, down the opposite side, along the bottom, and then up the near side and out the overflow.
Cool, but I have no over flow as I am sumpless. I have good flow but wanted to ask about it. thanks
Do your corals blow one way ? or do they go everywhere?
 

rlablan

Active Member
A wave maker of some sort could help them to go different directions. I see my corals moving but I don't think the go "one way" per se. You could also switch the directions of the powerheads every once in a while.
 

drtito

Member
I could put the power heads on timers set to random or something like that.
Looks like I will be playing with the power heads again.
good times
 

rlablan

Active Member
You could place 1 on each end, and then set them up on like an X10 timer or a lamp timer, and then you could set them up to turn on/off at different times. Alternate the sides and then only have 1 on at night or something... I dk.
Sounds like an interesting idea to me
Also, I think the X10 timers are about 20 bucks and it's just as simple as plugging in. It'd be a lot cheaper than real wave makers.
 

angler man

Member
Here's a quick question. How soon after mixing salt can you trust the reading to adjust the salinity? Does temp effect the reading in any way shape or form?
 
Top